Anyone figure this out yet? I’m losing my mind. I saw chairmanwon was working on a jig but it never released and I looked around for a beta but didn’t find anything on DDRC or BLC.

  • Lazycat@forum.guncadindex.comEnglish
    2·
    1 month ago

    The whole point of this is to design a hand bendable solution. Sure we can bend it perfectly with press and what not but that will filter out 95% of the people. To be honest the bends you have look pretty good (just from the picture), remember the RXM frame will also provide some support and alignment for parts which are not perfect, as long as the rails are leveled, slide slides and locking block + trigger housing fits in this should be golden.

    • AlexPhoenix@forum.guncadindex.comOPEnglish
      2·
      1 month ago

      i need to pickup the magpul frame and the OEM internal parts required. i just printed the locking block and rear trigger housing to test. i may have a larger vise downstairs that would be able to bend using my jigs a little better. idk, work in progress.