Ive been trying to print out the ftn 4 556 version and i want to print it out of pa6 but I keep getting very slight warping im using blkfde300 settings using p1s using gluestick on my bed preheating the chamber and drying the filament in a dryer before and during printing normally i just orient it to a 45° angle but the stl has the built in supports and i havent found a version that is without supports any help appreciated
Is it warping off the plate, or is the plate lifting? I had plate lift, so I bought a cfx plate from darkmoon which is thicker steel, no glue, and no more warp
yeah its curling on the edges off of the plate. I took a look at the cfx plate and might have to try it
Highly recommend them, with critical/large prints I also paint some vision miner glue on the plate as well, although I dont use it on shorter prints and I’ve never had edges lift
Thanks!!