They’re trying to preserve a sinking ship, serious members are migrating here slowly, there’s never gonna be a better option than a dedicated space for us

Yeah we’re pretty much not allowed to mention gci/odysee at all due to reddit being owned by private interests. That’s essentially what got fosscad nuked, coupled with sales happening over the platform

I use a cheap ninja 6qt that maxes out on dehydrator mode at 195f for 12-24h on new rolls, and print from a polymaker drybox with the 5% air exchanger mod stacks between the heater base/boxes. I also opened the heater + snipped out the plastic mesh, then super glued some SS mesh in its place, as recommended by the air exchanger designer. No issues with pa6, paht, ppa fibreheart, or pps. Less dry time for less hydroscopic materials like ppa, more time on the opposite end of the spectrum like pa6

Just put the roll/estimated print info, 300g fiberon/siraya tech/bambu pa6/ppa/pps-cf/gf etc. With a lathe and welder you would put 2" x 6-10" gr5 Ti etc. The minimum wage desk jockey is not a subject expert, they won’t know what the fuck you’re talking about regardless, it’s for proof of work in a court setting so give your potential lawyer solid ammunition to mic drop and send you home

Highly recommend them, with critical/large prints I also paint some vision miner glue on the plate as well, although I dont use it on shorter prints and I’ve never had edges lift

Is it warping off the plate, or is the plate lifting? I had plate lift, so I bought a cfx plate from darkmoon which is thicker steel, no glue, and no more warp

I upgraded the gears with HS simultaneously with the high temp modded HS nozzle install, all bambu official parts

P1S for me: all I did was swap to a hardened steel nozzle+gears, installed voxelpla detached motion feet instead of the solid rubber pads, switched to lan mode, and got a couple build plates from darkmoon(satin/cfx). I have a separate hs nozzle I wired a 33ohm resistor in-line to up nozzle temps as well, just haven’t installed it yet. I print from a polydryer with the printed 5% air exchanger mod+mesh plastic upgraded to SS window screen on the dryer, so I cant speak for the ams/2. Fiberon pa6/pet/pps