Have you considered a 9mm? I have been looking for a bolt/lever for 9mm forever. With a 5.45 bolt face, the only thing that would need to be reworked would be the ejector. Either way, this is a badass design. Looking forward to the release!
It can accept any standard shape AR bolt and barrel, I don’t know about 9mm specifically, but if there are mag internals that work you could probably modify them to fit. A new design would probably be more effective though.
It wouldnt be able to work with a 9mm bolt. It would have to be an ar15 bcg with a 5.45 bolt face. That will reliably seat a 9mm every time. You would then need a cmg 9mm delayed blowback barrel. Essentially it would be the same setup as an ar15 but with a 5.45 bolt face and cmg 9mm barrel. The only problem would be ejection. I have this setup with a BCA bolt upper on my an ar15 lower. I use printed mags. It works but because its still using the ar15 ejector and the 9mm casing is shorter it ejects into the receiver instead of out. I have tried figuring out how to make it work flawlessly but still havent found a way. The only way I see it working would be to cut the BCG into shape of a 9mm bolt to allow a 9mm magazine ejector, or after cutting the bcg you could add a permanent ejector inside the upper receiver.
I might try to build this around the 9mm and see how ejection works because with my bolt setup it eject decently if I rip the bolt back. With a lever it might actually be more reliable.
Is this a single shot? Or is there a magazine of some sort?
It has a 10 round internal magazine
Have you considered a 9mm? I have been looking for a bolt/lever for 9mm forever. With a 5.45 bolt face, the only thing that would need to be reworked would be the ejector. Either way, this is a badass design. Looking forward to the release!
It can accept any standard shape AR bolt and barrel, I don’t know about 9mm specifically, but if there are mag internals that work you could probably modify them to fit. A new design would probably be more effective though.
It wouldnt be able to work with a 9mm bolt. It would have to be an ar15 bcg with a 5.45 bolt face. That will reliably seat a 9mm every time. You would then need a cmg 9mm delayed blowback barrel. Essentially it would be the same setup as an ar15 but with a 5.45 bolt face and cmg 9mm barrel. The only problem would be ejection. I have this setup with a BCA bolt upper on my an ar15 lower. I use printed mags. It works but because its still using the ar15 ejector and the 9mm casing is shorter it ejects into the receiver instead of out. I have tried figuring out how to make it work flawlessly but still havent found a way. The only way I see it working would be to cut the BCG into shape of a 9mm bolt to allow a 9mm magazine ejector, or after cutting the bcg you could add a permanent ejector inside the upper receiver.
I might try to build this around the 9mm and see how ejection works because with my bolt setup it eject decently if I rip the bolt back. With a lever it might actually be more reliable.
Internal magazine using AR15 mag spring…
That’s amazing. I look forward to this release thanks for the info.