My Trash Panda (by AvieAtrix) haul…😅
This is definitely going on the printer as soon as it’s released!
What in tarnation is THAT?
It’s the TrashPanda by AvieAtrix… =)Let’s back up a step. What’s the base rifle?
No base rifle, uses an ar bolt and barrel
Bro this looks amazing!!!
Can’t wait for release.
This is just a standard 5.56 barrel right? What are you guys doing about the gas port?
Yes… I just reversed the gas block the the dev has a few suggestion on how to cap it.
Dope. How difficult was the build?
Not bad… Drilling and tapping holes on the bolt carrier is the most difficult part.
Drilling and tapping? I know its gotta be cut down right?
Yeah. The lever has to attach somewhere.
Ha that makes sense.
Damm that is one fine looking gun
Please AvieAtrix I need this~~~~
Is this a single shot? Or is there a magazine of some sort?
It has a 10 round internal magazine
Have you considered a 9mm? I have been looking for a bolt/lever for 9mm forever. With a 5.45 bolt face, the only thing that would need to be reworked would be the ejector. Either way, this is a badass design. Looking forward to the release!
It can accept any standard shape AR bolt and barrel, I don’t know about 9mm specifically, but if there are mag internals that work you could probably modify them to fit. A new design would probably be more effective though.
It wouldnt be able to work with a 9mm bolt. It would have to be an ar15 bcg with a 5.45 bolt face. That will reliably seat a 9mm every time. You would then need a cmg 9mm delayed blowback barrel. Essentially it would be the same setup as an ar15 but with a 5.45 bolt face and cmg 9mm barrel. The only problem would be ejection. I have this setup with a BCA bolt upper on my an ar15 lower. I use printed mags. It works but because its still using the ar15 ejector and the 9mm casing is shorter it ejects into the receiver instead of out. I have tried figuring out how to make it work flawlessly but still havent found a way. The only way I see it working would be to cut the BCG into shape of a 9mm bolt to allow a 9mm magazine ejector, or after cutting the bcg you could add a permanent ejector inside the upper receiver.
I might try to build this around the 9mm and see how ejection works because with my bolt setup it eject decently if I rip the bolt back. With a lever it might actually be more reliable.
Internal magazine using AR15 mag spring…
That’s amazing. I look forward to this release thanks for the info.
