this is in the Qidi slicer so just find these same 2 settings in yours and give it a shot, my supports work very well but also pull off with zero left behind and little effort… this isnt a cure all for everyone obv but its a starting point and should solve quite a few ppls issue
How many interface layers are you using? I’ve been using 3 layers and Rectilinear Interlaced and I’ve been super happy with how easily my supports come off.
i just use my printer defaults for that, these are the only settings ive changed and its made it so just a little pressure removes the supports so i didnt mess with anything else. i try to do the minimum i can where things work to my satisfaction because im no coder or anything like that so i just stick to the smallest fine tuning i can