The assembly PDF says a 36 gauge drill bit, but the link goes to a 37 gauge. 37 is closer to 2.5mm which I think is the tap size for M3. Does it matter which one?
There are different tolerances for tapping into either metal or plastic, and in this case both 36 and 37 are in tolerance and were used in development. It’s my bad I missed putting the wrong link in the docs :P but either works.
The assembly PDF says a 36 gauge drill bit, but the link goes to a 37 gauge. 37 is closer to 2.5mm which I think is the tap size for M3. Does it matter which one?
There are different tolerances for tapping into either metal or plastic, and in this case both 36 and 37 are in tolerance and were used in development. It’s my bad I missed putting the wrong link in the docs :P but either works.
Perfect, thank you