this is in the Qidi slicer so just find these same 2 settings in yours and give it a shot, my supports work very well but also pull off with zero left behind and little effort… this isnt a cure all for everyone obv but its a starting point and should solve quite a few ppls issue
that and my default object xy distance was .35
Ah cool. I’ll check my setting in prusaslicer. Thanks for the tip
no prob! this is by no means a solution for everyone but more of a starting point for lots as im sure this wont work for alot of people but will for some but i try to change as little as i can until i get good results and this is about the smallest amount of changes i could make with getting great results