This place is a prison! You’re not my real dad!

(Jk form 1’s are free now. I’ve gotten back 3 since Jan 1 and I’ve got like 5 more to go.)

Not only are they a great filament, but they also support 2a stuff. Give them your money!

Ah cool. I’ll check my setting in prusaslicer. Thanks for the tip

When I was trying to hammer the tube in I ended up getting jb weld everywhere so I just went with it and covered the entire tube in jb weld and a little sand for grit. Then I rattle canned it with some high temp paint. So far it’s worked great.

So wait, you’re suggesting changing the interface pattern?

Is this sailing?

Looks like I need to do a hotend upgrade. Thanks for the insight.

Interesting. So far, I’ve only been printing cans. I’ve been using PA6 for that.

What are the advantage to PPA over pa6? I’ve never printed that filament at all.

PpA over PA6?