First ever build was the Spectre SI15. Build guide said to melt a brass threaded insert into the lower. That way the pistol grip would be screwed into metal instead of plastic.

Reading the Ubar3 guide, Ivan chose to tap threads into the lower. I trust Ivan’s judgement because he’s been polishing the ubar for 10ish years. In my mind though… the brass threaded insert seems like it’d be stronger since it’s metal on metal. Harder to strip out the threads etc.

Thing is… with Ivan’s method you can use the actual screw that’s meant for the pistol grip. If you use the threaded brass insert. It’s a much smaller flanged screw. I’m not sure what to think.

Would appreciate thoughts/advice.

  • Kopsis@forum.guncadindex.comEnglish
    1·
    1 个月前

    Find the nut on https://www.mcmaster.com/ (for example https://www.mcmaster.com/products/nuts/hex-nuts-5~/hex-nuts-2~~/system-of-measurement~metric/thread-size~m5/). Click on the part number to bring up the detail window and you’ll see a CAD Download button. Select “3D-STEP No Threads” and click “Download”. You can load the downloaded STEP file directly into your slicer as a “Negative Part”. Position it where you want it and you’ll get a recess the correct size and shape.

    If the fit is a little tight when you install the nut (this method gives you no extra tolerancing), just heat the nut with a soldering iron like you would a threaded insert and it should easily press into place. Alternatively, you can scale the negative part up a few percent in the slicer to create some tolerance. Test by adding the scaled negative to a simple cube and iterating on that until you get the fit where you want it.

    • JohnJacobJingleTiT@forum.guncadindex.comOPEnglish
      0·
      1 个月前

      Dangggggg McMaster Carr is bad ass. I’ve made a few purchases from them and never noticed you could do that.

      I’ll probably just go with a m4 or m5 screw/nut so I don’t risk weakening the lower by removing too much material.

      Hypothetically though, If I wanted to use the original ar screw…… From what I’ve gathered, most ar grip screws are 1/4”-28 fine unf. So that means I’d need a 1/4”- 28 fine unf nut?

      I’ll probably use m4/ m5 screw/nut to minimize risk of weakening the fin by removing too much material. Smaller screws make me a tad nervous though.