C’mon anything other than 100% infill on a suppressor? Those thin pieces aren’t gonna survive the blast in a polymer config.

Real and true

Literally violates the first amendment so I don’t think it’ll happen

It should be fine. If the website accepted it it should go through. I had an issue with mine I had gotten through printscan for capital armory. Worked a year ago and then wouldn’t recently. Had to edit the files in an encrypted viewer but I also emailed print scan to fix it which they did in a few days. Now I have 3 working copies. It’s all the same info so it doesn’t matter which one I submit.

Depending on printer you can dry it on the bed itself. I have a P1S resistor modded bed. Setting to “100C” makes it go to 130C and actual measured temp is around 110C. I cover the spool with an aluminized mylar sheet lined spool box to reflect heat. Leave it there for 10-12 hrs occasionally flipping and measuring the weight. Once I don’t get any more change in weight it’s done, I pulled out 10 grams of water on a new spool of sunlu pa6-cf. Then I feed through the eibos dryer box to keep dry during the print. I’ve been getting flawless results.

Best to just watch from afar now. No point in salvaging if you got hit with the friendly fire stray from the mods. Reddit is gonna reddit and if you were serious about printing guns you would have already come here. I made numerous references to here without directly linking and got an immediate ban.

There are some ultimak gas tubes that give you a pic rail it’s a 1-1 swap with the normal gas tube. Made of aluminum and they clamp directly to the barrel. Not sure of any printed options. If you’re willing to cad you could slap some rails on Ivan’s dong.

Do you mean replace the receiver? My plastikov (v4) still uses the original hand guard/gas tube and pistol grip. There is a printable dong grip out there. Not so sure about gas tube. Definitely some printed grips out there. The stock can be whatever you want now that it’s a picatinny rail. MAF arms has the necessary parts to complete a printed plastikov v4 after you’ve removed the front trunnion. Or you could buy one of their populated barrel assemblies and start a new build there.

Ya pet cf is just a bit too stiff for taking loads like that. It’s good for mags and grips and rails. I’ve heard pet gf is better and I’ve been using that a lot more for frames.

okaayyyy

Removed by mod

It is easier and much more cost effective to just get a neoprene sheet and cut the wipes out yourself.

Glue is necessary with nylons on the textured pei bed. It will curl up and break away instantly without it. I bare hand cf nylons and my skin is fine. I feed from an ams with dessicant to keep it dry during print. Annealing is a hot button topic and not always necessary.

whats wrong with maf?

MAF arms

3d nail or a finishing nail of sufficient girth that you cut down.