i know i remember seeing him say somewhere that hes getting really nice results with .6 nozzle at .12(?) layer height and .5(?) for the rest of the lines.
my question is are those the actually the correct settings or am i misremembering? i been trying to find where i saw his post but im starting to think this may have been Mandela Effected
I probably spent a year or so really tinkering back and forth. I do have some PLA settings that work pretty dang good. I can upload a 3mf file to my Odysee with them on there. I have incorporated the fuzzy skin into them to allow the lines to basically disappear. I run my fuzzy skin at .07/.07 to do this, but I’ve also changed up support settings, jerk, and acceleration to help as well.
Damn. A year printing nylon couldn’t have been cheap. I used kgs of pla trying to grasp calibration/slicer settings etc. Then tried nylon cf, It was perfect first try. Couldn’t believe it.
Some pla settings would be greatly appreciated. I think it’d help a lot of ppl learn. For example I always thought aligned seams were too weak. Then I saw your settings. Asked the boys on Reddit, they confirmed aligned is the way. At least for pa6.
If you have a minute could I ask a few more questions? I don’t want to wear out my welcome bombarding the general discussions thread.
Sure brother! That’s what I enjoy doing. I like to help people and what other way to get help than to ask questions.
Thank you. I’m gonna message you.